Operation Of Powertank Lithium Pro; Charging The Battery; Checking The Remaining Battery Charge; Charging Usb Devices - Celestron PowerTank Lithium Pro Bedienungsanleitung

OPERATION OF POWERTANK LITHIUM PRO

Charging the Battery

1. Determine which AC plug adapter you need for
your location and slide it into place on the
charger body. Make sure it is fully seated and
snaps into place.
2. Pull the rubber cover from the charging port on
the side of the PowerTank Lithium Pro and plug in
the charger's cable.
3. Plug in the charger to your electrical outlet. The
adapter can accept an input of 100 to 240V
at 50/60Hz.
4. The battery indicator lights will blink when
charging. When charging is complete, all of the
lights will remain lit.
NOTE: If you are traveling internationally with this device,
it may be necessary to change to a different plug adapter.
Simply depress the locking button on the charger (located
directly below the plug), slide the plug adapter off and
replace it with the adapter you need.
Warning: The charger has an output of 16 Volts DC. Do
not attempt to use this charger to power your telescope
directly or significant damage to your telescope will result.
I
4 ENGLISH

Checking the Remaining Battery Charge

Press the power button once and the battery indicator
lights will light up showing the amount of power left in the
battery. All four lights means the battery is full, 3 lights is
75%, 2 lights is 50% and 1 light is 25%.

Charging USB Devices

Lift up the rubber seal on the top surface of the PowerTank
Lithium Pro to expose the control panel. Plug one end
of the USB charging cable that came with the device
you wish to charge into one of the two USB ports on the
PowerTank Lithium Pro. Plug the other end of the cable
into your device. Press the Power button on the control
panel once to begin charging. A red light will appear
next to the USB port showing that the power is flowing.
The charger automatically shuts off when the load drops
below 100mA for 1 hour. If you want to end the charging
session early, simply unplug your device's cable from the
power supply. To turn the battery off press and hold the
Power Button for two seconds.
Some devices such as smartphones and tablets have
quick charging technology. The PowerTank Lithium Pro
has one USB port that supports quick charge devices.
Please make sure you attach your compatible device
into this port to take advantage of the additional speed.