Emptying The Capsule Receptacle; Repair/Maintenance - MITACA I9 Bedienungsanleitung

Once coffee/tea is prepared
Once you have prepared coffee/tea you can eject the used capsule as follows:
1.Lift the control lever backwards (the capsule will drop into the receptacle provided)
NOTE Used capsules may get stuck inside the machine if they are not ejected straight away. Empty
the receptacle on a regular basis.
2. If you are going to make another cup of coffee/tea, introduce a new capsule and repeat the
coffee/tea making procedure. If you are finished, lower and lock the lever
SAFETY AND ENERGY-SAVING TIPS:
If you are going to be away from home for some time, remember to power off the machine at the
main switch (on the back). Do the same at night before going to bed. The coffee machine heats
up very rapidly and is normally ready for use in 1 minute after power-on.
If you plan not to use the coffee machine for a long period of time, empty the tank and unplug the
appliance.

Emptying the capsule receptacle

It is advisable to empty the capsule container regularly to
ensure that they do not get stuck. To do this you must extract
the capsule container (6) (Fig. 12). Empty the capsule
container and rinse it. Clean the drip tray and the grid to
remove residue of water and coffee. Once clean, replace
the drip tray with the capsule container (Fig. 13).
Storing t he cof f ee mac hine away
Power off and unplug the machine if it is not going to be
used for a prolonged period of time.
Store the coffee machine in a dry place, away from dust and
out of the reach of children.
We would advise you to store the machine in its original
packaging.
Temperatures in the storage area should not be lower than
5°C, to avoid damage to the inner parts of the machine from
water freezing inside it.

Repair/maintenance

In the event of a malfunction, or if the machine is dropped
and a defect arises or is suspected, unplug the machine and
call an authorised service centre. Never operate a defective
machine.
Only authorised service centres can service or repair the
appliance. The manufacturer disclaims responsibility for any
damage and/or injury that may result in the event of service
that is carried out in breach of the applicable safety regulations
or is executed by unauthorised personnel.
Fig. 12
Fig. 13
22
6
6