Gear Selection; Operation; Service; General Inspection - Westfalia 90 05 95 Originalanleitung

To remove the quick coupler, put the wrench back in and pull them
away from each other.
3. Draw back the locking sleeve on the quick coupler to insert the
agitator (1). Push forward the locking sleeve to lock the agitator in
place.

Gear Selection

The mixer is equipped with an electronic speed regulator and with a 2-
gear drive. Use the gear selection switch (4) to select one of the two
available gear speeds. The Machine must have come to a complete
standstill before the gears are changed.

Operation

1. Firmly hold the electric mixer with both hands.
2. Press safety button (7) the ON/OFF switch (8) with one hand. When
the device is operating there is no need to hold down the safety
switch
3. To switch off the device, release the ON/OFF switch.

Service

WARNING: Always disconnect from the mains power supply, before
carrying out any maintenance/cleaning of the charger. Remove the
battery before carrying out any maintenance/cleaning of the tool.
Note: Both the tool and the charger contain no user-serviceable parts. If
the device does not perform as outlined in this manual, turn to the
Westfalia customer service or to a competent professional.

General Inspection

 Regularly check that all the fixing screws are tight as they may
become loosened during use due to vibration.
 Inspect the supply cord of the charger for damage or wear prior to
each use. Repairs should be carried out by an authorised service
centre. This advice also applies to extension cords used with this
tool.
Operation
23