D-Link DAP-2360 Installationsanleitung Seite 4

To power the access point, you can use one of the following methods:
1. Use the supplied power adapter
2. Connect one end of your Ethernet cable into the LAN (PoE) port on the DAP-2360
To setup and manage the DAP-2360 from a computer, use one of the following methods:
1. Connect a straight through Ethernet cable between the access point and your
2. Connect the access point to a switch or router and use a computer from a
3. Please start your web browser program, type the
4
DAP-2360_A1_QIG_v1.00(EU).indd 4
and the other end into one port on a PoE switch.
PoE Switch
computer.
computer that is also connected to that switch or router.
IP address of the device (http://192.168.0.50) and
press Enter. Make sure that the IP addresses of the
device and your computer are in the same subnet.
Then, refer to the Manual for configuration.
DAP-2360
OR
Computer
D-Link DAP-2360 Quick Install Guide
2011/9/15 下午 05:04:42