Plamen International GLAS FRANKLIN Technische Anleitung Seite 34

We call upon you to CAREFULLY READ THESE INSTRUCTIONS, which will enable you to achieve
optimum results at the very first use.
TECHNICAL DATA:
DIMENSIONS H x W x D:
WEIGHT:
RATED OUTPUT:
EXECUTION TO EN 13 240:
FLUE CONNECTION – rear and top:
HEIGHT OF REAR FLUE CONN. – FROM THE FLOOR
INSTALLATION INSTRUCTIONS
Glas Franklin is shipped in a carton box fixed on a transport pallet. Preferably, the stove should be
unpacked at the place of installation. The stove is designed for rear of top flue connection.
The stove is delivered prepared for top flue connection. With four screws M6x20, fix the flue
connection collar, together with flue gas damper, to the top plate.
To connect the stove on the rear side, remove the rear guard plate cover (315.1) and rectangular flue
opening cover (002). Install flue connection together with the flue gas damper. Cut out an opening
Ø165 for the flue connection on the cover, and fix the guard plate cover to the rear guard plate (309).
Fix the rectangular flue opening cover on the top plate (019).
Install the front plinth (004.1) as shown on the cover page figure.
Ambient requirements
If the stove is to be installed in a room with combustible or heat sensitive flooring, it shall be placed on
a solid, non-combustible floor protector. The floor protector shall be dimensioned to extend at least 60
cm to the front of the stove and 40 cm to the rear and lateral sides.
Minimum back and lateral clearance between the stove and heat sensitive materials is 20 cm.
Minimum clearance between the stove and heat sensitive materials exposed to direct heat radiation
in front of the stove is 120 cm.
Make sure that the stove is placed on a level surface in a room with sufficient fresh air supply to
support combustion. If any aspirator (hood) or a similar air consuming unit is installed in the same
room, a separate opening, protected with anti-clogging mesh, shall be provided for regular fresh air
inflow.
Connecting the stove to the chimney
For the stove connection to the chimney, use common (standard) stovepipes and elbows with
incorporated dampers. Nominal diameter of the stovepipe is Ø 150 mm.
Make sure that the stovepipes (elbows) and firmly and tightly inserted in the flue connection collar.
Also, make sure that stovepipe sections are tightly fastened together and that the connections of the
stovepipe with the flue outlet and with the chimney outlet are firm and tight. The stovepipe shall not
protrude into the cross section of the chimney. In mounting the Stove please follow the national and
European standards as well as the local regulations applicable to this type of appliances.
OPERATING INSTRUCTIONS
First firing
Start the fire with a small amount of crumpled newspaper and thin dry kindling. Maintain a moderate,
evenly burning fire. Read the instructions concerning the air supply controls on your stove. Some
parts of the stove are painted with heat resistant paint. With the first firing, fumes of a characteristic
odour may be given off due to the gradual setting of the paint. Therefore, make sure that the room is
well aired during and after the first firing.
Never place any objects on the stove during the first firing and do not touch painted parts to avoid
damage to unset paint coat.
Fuel
Glas Franklin stoves are designed to burn wood and brown coal briquettes.
Use only well-seasoned, dry wood to reduce the likelihood of greasy soot buildup on the chimney
walls, which may cause clogging of the chimney.
80 x 86 x 63 cm
145 kg
10 kW
1a
Ø150 mm
H= 69 cm
34