Beper 50.928A Betriebsanleitung Seite 11

Steam Mop Use instructions
How to assemble your steam mop
1.Remove all the parts from the packaging .
2.Push telescopic tube into body with full force and make the locking spring locked.
3.Push the mop head to the body and make the locking spring locked.
4.Place the pad on the mop head and pull the string tight.
Filling the water tank
IMPORTANT: always insure that the unit is "UNPLUGGED" from the wall receptacle prior to initial
filling and before the bottom of the mop head .never use the steam mop without the micro-fiber cle-
aning pad attached to the mop head .
1.Turn the cap counter clockwise and then lift up to remove from the water tank.
2.Using the measuring cup and funnel ,pour some water into the water tank .do not overfill the unit
passed the "MAX" fill line on the water tank .
3.Replace the cap onto the water tank.
Using the steam mop
IMPORTANT: Never use the steam mop without the micro-fiber cleaning pad attached to the mop
head or without water in the water tank .
Warning: when water tank is empty, the pump will little pumping noise and shake, pump switch must
turn off immediately.
1.Sweep or vacuum floors before using the steam mop .
2.Twist the quick release cord holder to unwrap the power cord completely .
3.Plug into a 120-voit electrical outlet
4.Power indicator (green) turn on
5.It takes approximately 30 seconds for the unit to heat up and the steam to be ready
6.Turn on the pump switch (0-off , I- on),steam will wet micro-fiber. Its normal that pump will little
noise and shake when beginning.
7.When the water tank is empty ,the pump will be little pumping noise and shake, pump switch must
be turn off immediately. .unplug the power cord from the electrical outlet and refill the water tank
following the instructions above .
8.When you have finished using the steam mop ,unplug the unit from the electrical outlet and care-
fully remove
9.Never leave the micro-fiber cleaning pad on the steam mop head when you have finished using
the steam mop
Operating instructions
Always remove the micro-fiber cleaning pad and wash in warm water with a mild detergent .Never
use bleach or fabric softener when washing the reusable micro-fiber cleaning pad .The micro-fiber
cleaning pad may be dried in a washing machine and dried in a clothes drier on low heat .We re-
commend that you air dry
IMPORTANT: Be careful when machine washing or drying with mixed fabrics as micro-fiber pads
will pick up lint from other stick to other garments .we recommend washing the micro-fiber cleaning
pads separately or placing them in a garment bag first
CAUTION: never store the steam mop with a wet or damp micro-fiber cleaning pad still attached as
this will damage your floors
11