Using The Vacuum Cleaner - Inventum STS725RC Gebrauchsanleitung

MOUNTING THE WALL MOUNTED HOOK
Install the wall mounted hook with the enclosed screws and plugs to the wall near a socket for the adaptor.
• Place the wall mounted hook [10] with the rounded end upwards against the wall.
• Mark wit a pencil the two holes on the wall.
• Drill two holes of Ø 8 mm on the markings of at least 4 cm deep.
• Push in the plugs.
• Fix the wall mounted hook on the wall with the screws.
CHARGING THE VACUUM CLEANER
Hang the vacuum cleaner with the bottom of the handle on to the wall mounted hook. Plug the connector of the adaptor in the inlet at
the back of the handle [14].
Plug in the adaptor. As soon as the adapter is plugged in the vacuum cleaner will charge.
The indicator light turns blue one bar at a time.
When the battery of the vacuum cleaner is empty, the charging will take 5 hours.
When the battery is completely charged, the four bars will light up continuously.
Always unplug the adaptor when the battery is fully charged. The adaptor may become warm during charging - this is normal.
TIPS
• A fully charged battery will give continuous cleaning of approx. 25 minutes.
• The battery has a build in self-protection safety. When the surface temperature of the battery exceeds 50°C or gets below 0°C, the
battery will stop charging. The charging will continue when the surface temperature of the battery is between 0°C and 45°C.
• During use the surface of the battery can not exceed 65°C. The battery will enter the self-protection mode and the battery will cut
off the electricity to the vacuum cleaner. When the surface temperature of the battery goes back below 65°C, the vacuum cleaner
can be used again.
• We recommend that you discharge the battery at least once a month and then fully recharge it, to maintain optimal performance.
Warning! Always ensure your hands are dry before placing the appliance on the charging stand.
Warning! Never touch the brush inside the turbo brush when the appliance is on.
Waarschuwing! Only use the original included adaptor to charge the vacuum cleaner. Ohter adaptors can damage the appliance and
even be dangerous.
5

using the vacuum cleaner

SWITCHING THE VACUUM CLEANER ON
Press the on/off button
on the handle button again and the vacuum cleaner will shut off.
The turbo brush will rotate automatically when the vacuum cleaner is switched on. The LED lights on the turbo brush only work in dark
areas. If the working area is bright adequately, the lights don't work. When you move the turbo brush into dark area, the lights will light
up.
USING THE VACUUM CLEANER AS A HAND HELD
The vacuum cleaner can also be used as a hand vacuum cleaner.
Disassemble the turbo brush and the tube.
The hand vacuum cleaner can be used with or without the turbo brush or with the combination crevice nozzle. Press the on/off
button [ 1 ] on the handle of the hand vacuum cleaner to switch it on. By pressing it again, you will shut the vacuum cleaner off.
The crevice nozzle can be used in two ways: with or without the brush. The upholstery nozzle
can be placed onto the crevice nozzle.
INDICATION OF THE INDICATION LIGHT
The vacuum cleaner has indication lighs which announce the battery with four bars ____.
1 bar _ flashing: battery is 1 to 8% full.
1 bar _ continuously: battery is 8 to 25% full
2 bars __ : battery is 25 to 50% full
3 bars ___ : battery is 50 to 75% full
4 bars____ : battery is 75 to 100% full.
STORAGE
Hang the vacuum cleaner after every use on the wall mounted hook.
When the vacuum cleaner needs to charged, make sure the adaptor is plugged in and the adaptor is connected to the vacuum
cleaner. Always unplug the adaptor when the battery is fully charged.
[ 1 ] on the handle of the vacuum cleaner to switch the vacuum cleaner on. Press the on/off button [ 1 ]
19
English •