Technical Specification - Orno OR-WAT-419 Bedienungs- Und Montageanleitung

FEATURES:
fig. 1
OPERATION:
SETTINGS
1. DISPLAY MODE:
2. DISPLAY AND SETTINGS:
The device is operated using the MODE and UP buttons
Connect the device to a grounded socket in a 230V~ power grid.
Deactivate the appliance whose power consumption you wish to measure and connect it to the
wattmeter.
Activate the appliance connected to the wattmeter.
Press the MODE button and hold it for 3 seconds in order to switch to the cost of electricity (in €/kWg)
setting mode. Press "UP" to go to settings.
Use the MODE button to select one of the following 5 modes: Power → Voltage → Cumulated amount
of electricity in kWh → Cumulated cost of electricity → Cost of electricity in €/kWh
Press "MODE" to select other settings.
Pressing and holding the „MODE" button exits the setting mode.
To fully reset the device and revert to its original settings, press and hold the RESET button.
NOTE: All real-time data will be refreshed every 1 second.
Power supply:
Maximum current:
Maximum voltage:
Range of displayed power：
Range of displayed voltage:
Range of displayed cumulative electricity (KWh)
Cumulative cost of electricity：
Cost electricity setting range:
Voltage measurement:
Measurement range:
Net weight:
The OR-WAT-419 wattmeter allows for checking
electricity consumption levels and calculating
the cost of energy used by the device connected
to the meter.
- large LCD display
- simple configuration of the cost calculation
setting
fig. 2
fig. 3

TECHNICAL SPECIFICATION:

230VAC, 50 Hz
16A
3680W
0,0W～9999W
0,0V～9999V
0,000 KWh～9999 KWh
0,00 €～9999 €
00,00 €/KWh～99,99 €/KWh
200V - 276V~.
0.1~3680W
0,120 kg
3