Wireless Maxg Adsl Gateway Installation - USRobotics Wireless MAXg ADSL Gateway Installationsanleitung

Wireless MAXg ADSL Gateway Installation

Thank you for purchasing the USRobotics Wireless MAXg ADSL Gateway.
For current product support and contact information, go to the following Web site:
NOTE: It is important that you have your serial number written down for future
reference. If you ever need to call our technical support department, you will
need this number to receive assistance. You can find your 12-character serial
number on a bar code sticker located on the bottom of the gateway and also on
the box. You will also need your model number. It is noted below.
Write your serial number in the space provided below.
Serial Number
What You Need Before You Begin
You will need active ADSL and Internet service from your local telephone company or
Internet Service Provider (ISP) before you try to go on the Internet. You may also need the
following from your ISP:
• VPI/VCI values
• ADSL standard (modulation)
• Encapsulation mode
• Authentication (PAP or CHAP) for PPP connections
• Your user name and password, if they were assigned by your ISP.
Gateway Installation
Step 1. Connect Microfilter (if included or required by your ISP)
A microfilter removes interference between voice and DSL signals. Your ISP will determine
if a microfilter is necessary. If a microfilter was not included with the gateway, you may
want to ask your ISP if you need to purchase one or more.
To install a microfilter, plug each device (phone, fax machine, or other telephony device)
into the microfilter, and then plug the microfilter into the telephone wall jack. Do not install
http://www.usr.com/support
9108
Model Number
3