Clear All - Emgeton C3 Pro Anleitung

TOUCH SCREEN LCD ON
If you set the Delay to On, that means the Touch screen is always on (It is convenient
to see the status but it is bigger power consumption). If you set up Delay to Off, the
Touchscreen will be on for some time and then be off after any operation on your
remote control and you can change the length of on time as below steps.
1. Press and hold the SET key on your remote control for more than 3 seconds, then
release it.
2. Press the or
3. Press the or
4. Press the or
5. LCD shows "Success!", this finishes the set-up
KEY BEEP CONFIRMATION
If the Beep is on, the Beep will be beep when you press any key.
1. Press and hold the SET key on your remote control for more than 3 seconds, then
release it.
2. Press the or
3. Press the or
4. Press the or
5. LCD shows "Success!", this finishes the set-up

CLEAR ALL

Erase all the setting up data, and go back to the factory default settings.
1. Press and hold the SET key on your remote control for more than 3 seconds, then
release it.
2. Press the or
3. Press the or
4. LCD shows "Sure Clear?", press OK key.
5. LCD shows "Success!", this finishes the set-up
Note:
1. To return to beginning status, please press the EXIT key or the device key (e.g. TV,
or VCR...)
2. The keys of
control You can't control your device as normal menu function at this moment.
keys to select "OtherSet" on LCD menu, confirm by OK key.
keys to select "Delay" on LCD menu, confirm by OK key.
key to select the value and then press OK key.
keys to select "OtherSet" on LCD menu, confirm by OK key.
keys to select "Beep" on LCD menu, confirm by OK key.
key to select the value and then press OK key.
keys to select "OtherSet" on LCD menu, confirm by OK key.
keys to select "Clear All" on LCD menu, confirm by OK key.
, OK, EXIT are only used to set-up your new remote
14