Emgeton C3 PRO Anleitung Seite 11

SET-UP BY AUTO SEARCH
If the set-up by brand and code failed or you cannot find the brand name in your remote
control screen, you may use the Auto Search to find the correct code to operate your
device.
1. Turn on the device (e.g. TV, DVD...) you would like to operate. If it is a VCR, Please
insert a tape.
2. Press and hold the SET key on your remote control for more than 3 seconds, then
release it.
3. Press the or
select "Auto Srch" of the LCD menu, confirm by OK key, then you press device key to
select your desired operation device (e.g. DVD) and then press the OK key to start the
Auto Search. (You must point your remote control to your device at this moment).
4. See if the device reacts or not, once the device reacts, please press any key to stop
the search.
5. Check the function of the keys (e.g. POWER CH+ CH- VOL+ VOL/MUTE). If none of
the keys of your new remote control can work, or most of the keys work improperly,
please try another code by the or key, until all basic functions operate properly,
6. LCD shows "Success!", then it finishes the set-up
SET-UP BY ENTERING CODE
1. Turn on the device (e.g. TV, DVD...) you would like to operate. If it is a VCR, Please
insert a tape, In the code list, please find the brand name and code no of your device
brand (e.g. Lifetec 003, 010, 062,).
2. Press and hold the SET key on your remote control for more than 3 seconds, then
release it.
3. Press the or
select "Enter Code" of the LCD menu, confirm by OK key, then you press device key to
select your desired operation device (e.g. DVD) and then press the OK key to enter the
code.
4. LCD shows "Success!", and then it finishes the set-up
5. Check the function of the keys (e.g. POWER CH+ CH- VOL+ VOL/MUTE). If none of
the keys of your new remote control can work, or most of the keys work improperly,
please try another code, until all basic functions operate properly.
keys to select "SetupCode" on LCD menu, then press OK key,
keys to select "SetupCode" on LCD menu, then press OK key,
11