Nilfisk-Advance BA 430S Bedienungs- Und Wartungsanleitungen Seite 39

Exterior rear overview
(See Fig. C)
1. Serial number plate/technical data/EC certification
2. Handlebar
3. Handlebar inclination adjusting knobs
4. Can holder
5. Tank cover
6. Steering rear wheels
7. Front wheels on fixed axle
8. Brush, or disk-holder and disk
9. Brush/disk-holder plate
10. Squeegee
11. Squeegee fastening knobs to the machine
12. Squeegee balance adjusting knob
13. Squeegee front blade
14. Squeegee rear blade
15. Rear blade fastening hook
16. Wing nuts
17. Recovery water drain hose
18. Solution drain hose
19. Squeegee lifting lever
20. Brush lifting pedal
21. Solution filter
22. Battery charger connector (optional)
23. Battery charger cable (optional)
24. Supplied key
25. Battery connection connector
26. Squeegee vacuum hose
27. Solution tank marks
28. Solution tap
08812942(3)2004-05 A
USE AND MAINTENANCE MANUAL
Front under cover and tank exterior overview
(See Fig. H)
1. Tank side fastening screw
2. Tank cover (open position)
3. Tank cover seal
4. Compensation hole
5. Recovery water tank
6. Solution tank
7. Recovery water vacuum hole
8. Vacuum grid with automatic closing with float
9. Recovery water draining hole
10. Vacuum motor
11. Brush motor
12. Electrical component box
13. Batteries
14. Battery caps
15. Battery assembly diagram
16. Electronic battery charger (optional)
17. Charged battery warning light
18. Lead (WET) or gel (GEL) battery selector switch
(optional, positioned on the optional electronic battery
charger)
19. Tank assembly
20. Brush/disk-holder plate (BA 510 version)
21. Brush/disk-holder plate (BA 430 version)
22. Machine forward movement adjusting knob
23. Machine forward movement speed adjusting knob
24. Brush
25. Disk-holder
26. Disk
27. Box with drive board and fuses of the drive system (*)
(*) BA 430S D / BA 510S D versions only
5