Auma 10031954 Handbuch Seite 21

for 2-3 seconds, the hours will start flashing, press REV/DOWN or FF/UP
to set the current hour, press the TIME_SET button to confirm the setting,
then the minutes will start flashing, press REV/DOWN or FF/UP to set
the current minutes, press the TIME_SET again to confirm all setting. The
time is now set
Alarm Setting
1. While the unit is in standby mode, press ALARM1/2 to open and close
the alarm SOURCE
2. While the unit is in standby mode, press and hold ALARM1/2 for 2-3
seconds, the alarm hour will start flashing, press REW/TUN- or FF/TUN+
to set your desired hour, press the ALARM 1/2 again, then the alarm
minutes will start flashing, press REW/TUN- or FF/TUN+ to set your
desired minutes, press the ALARM 1/2 again to set alarm mode, you can
press REW/TUN- or FF/TUN+ to set alarm buzzer or alarm radio or alarm
CD, press the ALARM 1/2 to confirm the setting
3. When the current time is same as the alarm set time, ALARM 1/2 will
start flashing, the alarm will be activated (the alarm will be closed 1 hour
later if without any operation). Press SNOOZE button into sleep mode,
the alarm will activated again 9 minutes later, press any buttons (except
the SNOOZE button) to close the alarm today
Remark: If the CD player cannot read the CD information, the alarm CD will
change to alarm buzzer automatic
Sleep SOURCE
Auto power-off SOURCE
When the unit is powered on, press SLEEP button to set the sleep time to
"90-60-30-15-OFF", the unit will power off then.
EN
21