Auma 10031954 Handbuch Seite 20

EN
20
3. Press the REPEAT/PROG to store the selected track in slot 1.The display
will now display P02 to indicate your selecting the track for slot 2.
4. Repeat steps 2 to 3 for every track you wish to program up to a
maximum of 20 tracks. If you try to program more than 20 tracks the
display will revert back to P01 and will overwrite the first slot again.
5. Press the PLAY/PAUSE/BAND to begin the programmed sequence
playback.
6. Should you wish to cancel the programming you can press the STOP
button to resume normal SOURCE
CD/ USB
In CD mode, Press the CD FUNCTON button to switch to CD / USB playback.
1. Press the CD FUNCTON button once for one second) changing to USB
SOURCE
2. Press the CD FUNCTON button twice (for one second) changing to SD
SOURCE
3. Press the CD FUNCTON button third times (for one second) it returns to
CD play. SKIPPING TRACKS Press during play CD/USB Backward---------
Press the CD REV Skip button Fast Forward---------Press the CD FWD Skip
button.
Connecting a USB device
Insert a USB key inside the connector. Remark: Depending on the capacity
of the device, the reading can take more than 1 minute.
The unit cannot read my USB device. Once you have plugged your device to
the unit, you may need to switch on the USB device before it can operate.
This unit does not support a direct USB connection with a computer. You
need to use a USB device, or a MP3 player. - If you are using a USB external
hard disk: you need to connect your device simultaneously to an external
power source and to the unit. If you are using a self-powered PMP, make
sure that the battery is sufficiently loaded. - Check that the files system of
your USB device is formatted into the FAT or FAT 32 format. USB device
formatted into NTFS are not compatible with this unit. Caution: if you
attempt to modify your file system, formatting your device will erase all
data. Please refer to your USB device's instruction manual first.
Clock Setting
The clock can be only set while the unit is in standby mode
1. While the unit is in standby mode, press the TIME_SET button into clock
setting. The LED display will start flashing, press REV/DOWN or FF/
UP to select 12h display or 24h display. Confirm your setting by press
TIME_SET again
2. While the unit is in standby mode, press and hold the TIME_SET button