Adsl 4-Port Router Installation - USRobotics 9107 Installationsanleitung

ADSL 4-Port Router Installation

Thank you for purchasing the USRobotics ADSL 4-Port Router.
For current product support and contact information, go to the following Web site:
NOTE: It is important that you have your serial number written down for future
reference. If you ever need to call our technical support department, you will
need this number to receive assistance. You can find your serial number on a bar
code sticker located on the bottom of the router and also on the box. You will also
need your model number. It is noted below.
Write your serial number in the space provided below.
Serial Number
What You Need Before You Begin
You will need active ADSL and Internet service from your local telephone company or
Internet Service Provider (ISP) before you can go on the Internet. You may also need the
following from your ISP:
• VPI/VCI values
• ADSL standard (modulation)
• Encapsulation mode
• Authentication (PAP or CHAP) for PPP connections
• Your user name and password, if they were assigned by your ISP.
Router Installation
Step 1. Connect Microfilter (if included or required by your ISP)
A microfilter removes interference between voice and DSL signals. Your ISP will determine
if a microfilter is necessary. If a microfilter was not included with the router, you may want
to ask your ISP if you need to purchase one or more.
To install a microfilter, plug a device (phone, fax machine, or other telephony device) into
the microfilter, and then plug the microfilter into the telephone wall jack. Do not install a
http://www.usr.com/support
9107
Model Number
3