Charge The Battery Pack; Charging In The Frame - Batavus ION Bedienungsanleitung

1.2

Charge the battery pack

All batteries start emptying over time. This process is called 'self discharge'. If
the battery is discharged too much, deep discharge will occur. A deep
discharge can cause permanent damage to the battery pack. In order to
prevent this situation, follow the charge instructions carefully.
The guarantee will be null and void when deep discharge is
established.
1.2.1 Charge
Connect the charger to the battery pack when the latter is not in use. The
system will then automatically recharge the pack whenever necessary.
If you cannot leave the battery pack connected to the charger, you can
disconnect it once the pack is fully recharged. In this case, do make sure to
connect the battery pack to the charger at least once every two months and
recharge it to avoid a deep a discharge.
Connect the charger to the bicycle when it is not being used. This
will lengthen the life of the battery pack.

1.2.2 Charging in the frame

1. Check that the power cable is properly
connected to the charger (A).
2. Connect the plug (C) of the charger to
the contact point (D).
3. Remove the charger before you start
cycling.
49
47