Troubleshooting - nedis BTTR100BK Anleitung

3. After being connected for the first time, the two devices will recognise each
other next time.
Connect the second set of headphones or music receiver:
1. Take the second set of Bluetooth® headphones or Bluetooth® music
receiver.
2. Press the pairing button (check the device manual).
3. Press the pairing button on the BTTR100BK once for approx. 1 ~ 2 seconds.
The LED light starts blinking while the transmitter searches for the second
set of headphones or music receiver. The device that was connected first, is
muted.
4. If the devices are connected, the LED light is constantly switched on.
Note
The BTTR100BK features the option to connect two Bluetooth® A2DP devices at
the same time. If you would like to connect a second A2DP device, you need to
reset the BTTR100BK to establish a new connection.
Reset
Press the pairing button on the BTTR100BK and release it again. The LED light
on the BTTR100BK starts blinking while the transmitter is searching for A2DP
devices nearby.
LED indication
Indication
Flash every 5 seconds
Constantly switched on

Troubleshooting

If you do not hear any sound coming from your headphones or music receiver,
check the following:
- make sure the BTTR100BK is powered;
- make sure the audio cable is correctly connected to the BTTR100BK;
- make sure that the audio source is working properly;
- make sure the volume of the audio source is set correctly;
- make sure your device is at a maximum distance of 10 metres of the audio
transmitter.
Meaning Description
Pairing Searching for a device in pairing mode
Connected BTTR100BK and device are connected
3
ENGLISH