Eizo CG241W Installationshandbuch Seite 10

Connecting the measurement device
Connect your measurement device to the USB downstream port on your computer or keyboard, or the
USB port on your monitor.
Note
• The measurement device is not included in this product.
• Refer to the User's Manual for the measurement device in regard to connection.
No-Picture Problem
If no picture is displayed on the monitor even after the following remedial action is taken,
contact your local dealer.
. Check the Power indicator.
Symptom
No picture
. Check the error message that remains on the screen.
These messages appear when the input signal is incorrect even if the monitor is functioning.
Symptom

Status
Power indicator does not light
up.
Power indicator lights blue.
Power indicator lights orange.
Status
The input signal is not received.
The signal frequency is outside
the specification. Incorrect
signal frequency is shown in
red.
Possible cause and remedy
• Check whether the power cord is connected
correctly. If the problem persists, turn off the
monitor, and then turn it on again a few
minutes later.
• Press .
• Set high values for Gain RGB levels.
• Switch the input signal with
• Press a key on the keyboard or click the
mouse.
• Turn on the PC.
Possible cause and remedy
• Check whether the PC is turned on.
• Check whether the signal cable is properly
connected to the PC.
• Switch the input signal with
• Reboot the PC.
• Change the mode to an appropriate mode
using the graphics board's utility software.
Refer to the manual of the graphics board for
details.
.
.