Switch Installation / Switch-Installation
Contents of the switch installation kits / Inhalt der Switch-Installations-Kits
a
Kit 1:
b
c
a
Kit 2:
b
c
d
d
Installing the Cicso switch 3750-x /Cicso Switch 3750-x montieren
Step 2: Attaching the switch / Switch befestigen
Step 3: Connecting the power cable / Netzkabel anschließen
The figure on the left shows the contents
of the two switch installation kits:
a Cover
b Cage nuts
c Screws with special washers
d Mounting brackets:
- Kit 1 = long mounting brackets
- Kit 2 = short mounting brackets
Mount the brackets on both sides of
►
the switch housing as shown, using the
countersunk screws supplied with the
switch (see circles).
Torque: 2 Nm
On the back of the rack, place two cage
►
nuts on each side in the corresponding
positions to accommodate the special
screws.
Insert the switch into the rack above the
►
shelf plate.
Fix the switch in place with two screws
►
with special washers (see c in figure
above) on each side (see arrows).
Torque: 2.5 Nm
Feed the power cable through the
►
nearest hole in the shelf plate (see
circle).
v
Be careful not to damage the
power cables.
Das Foto links zeigt den Inhalt der beiden
Switch-Installations-Kits:
a Lochblende
b Käfigmuttern
c Schrauben mit Spezial-Unterleg-
scheiben
d Montage-Winkel:
- Kit 1 = lange Montage-Winkel
- Kit 2 = kurze Montage-Winkel
Schrauben Sie die Montagewinkel
►
wie abgebildet mit den zum jewei-
ligen Switch mitgelieferten Senkkopf-
Schrauben an beide Seiten des Switch-
Gehäuses (siehe Kreise).
Drehmoment: 2 Nm
Setzen Sie ander Rückseite des Racks
►
auf beiden Seiten je zwei Käfigmuttern
an die entsprechenden Stellen zur Auf-
nahme der Spezialschrauben.
Schieben Sie den Switch an der Rück-
►
seite des Racks über dem
Shelf-Boden in das Rack ein .
Befestigen Sie den Switch mit zwei
►
Schrauben mit Spezial-Unterlegschei-
ben (siehe c in Abb. oben) (siehe
Pfeile).
Drehmoment:2,5 Nm
Führen Sie das Netzkabel durch die
►
nächstgelegene Aussparung des Shelf-
Bodens (siehe Kreis).
v
Achten Sie darauf, dass die
Netzkabel nicht beschädigt
werden.