Programming - CareTech Gloria+ Benutzerhandbuch

Programming

The carephone's telephone numbers, alarm codes and settings are
programmed via a computer, using the programming cable and the
CareTech CS software.
For help with programming and information about other programming tools,
please refer to the carephone's technical handbook or contact your supplier.
In some cases, the carephone can be delivered ready-programmed by the
supplier.
Programming radio triggers
Up to nine radio triggers or other radio-alarm transmitters, e.g. smoke
detectors, can be programmed for the carephone.
Programming radio transmitters:
Hold down the green button for approximately four seconds until the
•
green "On" light starts to flash.
Press the radio trigger. Once the carephone has received the radio
•
signal, you will hear a distinct tone signal.
Confirm by pressing the red button on the carephone.
•
Check radio coverage
This should always be done on installation.
Hold down the green button for approximately four seconds until the
•
green "On" light starts to flash.
Press the radio trigger. The built-in speaker will produce a tone
•
signal on successful reception. Repeat this in all areas where the
alarm needs to operate.
17