Installation - CareTech Gloria+ Benutzerhandbuch

Installation

Connection
The carephone is very simply to install, connection to the telephone network
is via the telephone lead/adapter.
The carephone should be connected to the master telephone socket in the
home in order for it to continue to work even if a telephone receiver is left off
the hook or is faulty. The master socket is normally the one closest to the
entrance door – for further advice, contact your supplier.
Power is supplied via the power supply from a wall socket.
Disconnect the existing telephone from the telephone jack and connect
•
the telephone lead/adapter to the jack. Connect the telephone lead to
the TEL socket on the carephone.
Connect the power supply to the wall socket and the power supply lead
•
to the POWER socket on the carephone.
Turn the power switch to the ON position. Check that the "ON"
•
indicator lamp has a steady green light.
Connect the existing telephone to the intermediate plug. Lift the receiver
•
and check that you can hear the tone.
Carry out a test alarm from the carephone.
•
OFF ON TEL
16
POWER