P.Lindberg 9058167 Original Bedienungsanleitung Seite 185

Problem
The pump is primed but
cannot create a good spray
pattern.
P. Lindberg A/S
Tel.: +45 70 21 26 26
Cause
The inlet strainer is clogged
or the suction hose is not
submerged in the paint.
The inlet valve ball or seat is
dirty.
The suction hose is leaking.
The return valve ball is stuck.
The Prime/Spray valve is
worn or clogged with dirt.
The nozzle may be partially
clogged.
The rotary nozzle is in the
UNCLOG position.
Impurities in the paint.
The pressure control is set
too low.
The spray gun filter is
clogged.
The nozzle is too big in
relation to the equipment
capacity.
The nozzle is worn so it is no
longer suitable for the
equipment capacity.
The nozzle gasket and seal
are worn or missing entirely.
41
Sdr. Ringvej 1
DK-6600 Vejen
Solution
slowly and stops. Repeat
several times if necessary.
Clean the strainer and make
sure the suction hose is
submerged in the paint.
Remove the valve and clean
or replace the ball or seat.
Inspect the hose for cracks
or other damage.
Unscrew the valve and clean
it.
Contact an authorised
workshop.
Clean the nozzle.
Turn the arrow-shaped
handle on the nozzle holder
so it points forward to the
SPRAY position.
Strain the paint.
Increase the pressure.
Clean or replace the filter in
the gun.
Replace the nozzle.
Replace the nozzle.
Replace the gasket and seal.
MAN 9058167 EN V1
www.p-lindberg.dk
e-mail: salg@p-lindberg.dk