Herunterladen Inhalt Inhalt Diese Seite drucken

Conformity And Approval; Inserting Batteries; Switching On /Off Muting - Monacor JTS MH-36G2/5 Bedienungsanleitung

Mit uhf-sender
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

2 Important Notes
The unit corresponds to all relevant directives of
the EU and is therefore marked with
The unit is suitable for indoor use only Protect
it against dripping water and splash water,
high air humidity and heat (admissible ambi-
ent temperature range: 0 – 40 °C)
For cleaning only use a dry, soft cloth; never
use water or chemicals
No guarantee claims for the unit and no li-
ability for any resulting personal damage or
material damage will be accepted if the unit
is used for other purposes than originally in-
tended, if it is not correctly operated, or if it
is not repaired in an expert way
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harm-
ful to the environment
3 Applications
Combined with the JTS receiver US-36G2 / 5,
this dynamic hand-held microphone with UHF
transmitter creates a wireless audio transmis-
sion system (506 – 542 MHz) Just like on the
receiver, the transmission frequency can either
be selected from one of the 6 preset groups or
directly set in steps of 25 kHz

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the wireless microphone MH-36G2 / 5
complies with the directive 2014 / 53 / EU The
EU declaration of conformity is available on the
Internet:
www jts-europe com
Restrictions or requirements apply in the
following countries:
CZ
DE
IT
LT
In the Federal Republic of Germany, the wireless
microphone requires a frequency assignment
(for which a fee is charged) In other countries,
it is necessary to apply for a corresponding
approval Prior to operating the unit outside
EL
FI
FR
MT
PL
Germany, please contact the MONACOR sub-
sidiary or the corresponding authorities of the
respective country Links to the national author-
ities can be found via the following Internet
address:
www cept org
tECC
tTopics
tShort Range Devices (SRD) and other R&T TE
sub-classes
tEFIS and National Frequency Tables

4 Inserting Batteries

For power supply, two 1 5 V batteries of size
AA are required
Only insert batteries of the same type and
always replace both of them
If the microphone is not in use for a longer
period of time, always remove the batteries
as a precaution to prevent damage due to
battery leakage
1) Unscrew the microphone cartridge (1) (fig 3)
2) To unlock the battery holder (8), push the
latch (7) in the direction of the arrow (fig 4)
3) Pull out the battery holder to the stop (fig  5)
and insert the batteries with the positive and
negative poles as indicated on the holder
4) Push back the battery holder until it locks
5) Place the microphone cartridge on the han-
dle so that the connectors (6) of cartridge
and handle fit together, and then screw the
cartridge onto the handle
Never put batteries in the household
waste; always take them to a special
waste disposal, e g collection con-
tainer at your retailer
5 Switching on /off
Muting
To switch on, press the button
For detailed information on the display indica-
tions refer to chapter 1:
To mute the sound, press the button
briefly; the display will briefly indicate
When the sound is muted, the display backlight
(4) briefly
display (2)
9

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis