Home Automation Mode; Master Reset - X10 Europe UR86E Bedienungsanleitung

• Ensure that a compatible driver is loaded (by installing ShowShifter software see 3.1).
• Set the remote back to factory default (see paragraph 6.4).

6.3 Home Automation mode

The transceiver module doesn't respond to the remote
• Check the house code of the Transceiver Module is set to A. If you have change the House Code on the
remote (see 5.2), check that it matches the House Code on the module.
• Check that you have power to the AC outlet where the transceiver is plugged in.
• Check that your remote is programmed with the RF code (see 5.3.)
The Transceiver Module works, but other modules don't respond
• Check that the module has the same House Code as the Transceiver Module.
• Try plugging the Module into a different AC outlet.
• Set the remote back to factory default setting (see paragraph 6.4).
How to maximize the RF range
To obtain the best RF range, locate the receiver as far away from your PC as possible. This is to avoid
unwanted interference of the PC Remote's signals, due to RF radiation from your PC's microprocessor.

6.4 Master Reset

How to set the PC Remote back to factory default:
• Press and hold SETUP (4) until the LED indicator (2) lights steadily. Release SETUP.
• Press and release the STOP key (23) twice.
• Press and release the MUTE key (12).
• The LED (2) turns off after few seconds.
Important
The PC Remote must be used only in the way described in this instruction manual and may not be
used for a purpose not intended.
15