Manual Code Search; Automatic Code Search; Identifying Codes Found; Default Volume Control For Satellite - X10 Europe UR86E Bedienungsanleitung

4.4. Manual code search

1. Make sure your equipment is switched on.
2. Press and hold SETUP (4) until the LED indicator lights steadily. Release SETUP.
3. Press the mode key (3) that matches the equipment you want to control (for example TV).
4. Press Channel+ (9) repeatedly until the channel changes. If you step past the correct code use
Channel- (9) to go back to the right code.
5. When the equipment you want to control reacts press --/- (14) to confirm the code. That's all.
Note: If your equipment doesn't have Channel+ you can use PLAY (VCR or DVD) (22) or POWER (1)
key. The search starts after the last registered code. If that was 030, the search starts at 031 until the last
possible code and then goes from 000 to 029.
Note: if certain functions of your equipment can't be controlled you will have to find a different code for
your brand.

4.5. Automatic code search

1. Turn on the device you want to control.
2. Press and hold SETUP (4) until the LED indicator (2) lights steadily. Release SETUP button.
3. Press the mode button (3) that matches the equipment you wish to control. The LED (2) blinks once.
4. Press Channel+ (9) once. After a few seconds the remote starts stepping through the code library (fast
search, 1 code per second). When the device responds, you can press Channel+ (9) to switch to slow
search (1 code per 3 seconds). You can step back by pressing Channel- (9) (you can step forward by
pressing Channel+ (9) in case you went too far back).
5. As soon as the device responds again, press the --/- key (14) to store the code you found.

4.6. Identifying codes found

1. Press and hold SETUP (4) until the LED indicator (2) lights steadily. Release SETUP.
2. Press the mode key (3) for the equipment you want to identify (TV, VCR, DVD, SAT or AUX). The LED
blinks once.
3. Press again SETUP. The LED blinks once.
4. To identify the first digit press each number button from 0 - 9 (11) until the LED blinks. The number you
pressed is the first digit of the code.
5. Press each number key from 0 - 9 as above to find the second digit.
6. Press each number key from 0 - 9 as above to find the third digit. When the third digit has been found
the LED will go off.

4.7. Default Volume Control for Satellite

Because some SAT decoders may not have volume control, the PC Remote can control the television's
volume in SAT mode (no need to select TV mode). To choose the equipment that the Mute and Volume
keys will control in SAT mode, just proceed as follow:
1. Press and release the TV Mode button (3) - remote must be in TV mode for this procedure.
2. Press and hold SETUP (4) button until LED remains on.
3. Release SETUP button.
4. Press and hold the Mute (12) key for approximately 8 seconds. LED will stay off for the 8 second
period, then blink once to indicate volume default acceptance and then remain off.
5. Remote volume default is now set.
6. If the PC Remote was previously controlling the television volume in SAT mode, it will now control the
volume of the satellite decoder. If it was previously controlling the volume of the satellite decoder, it will
now control the volume of the television.

4.8 Learning functionality (UR86EL only)

Your UR86EL PC Remote has the codes for most TVs, VCRs, etc. in its code library. However, if the code
for your particular device is not found in the library, you can learn these codes from your existing remote.
Or if you find a code from the code tables included with this owner's manual that "almost" matches your
12