Inhaltsverzeichnis
Werbung
030504.02 r01 04-05
Use and maintenance
Inspect the strainer element regularly for
contaminents.
N.B. The lid doesn't need to be removed for
inspection.
Clean the strainer element if dirt has accu-
mulated.
Cleaning model 1320
Close the seacock before unscrewing the
lid of the water strainer, see drawing 7.
Remove the strainer element out of the
housing. The strainer element consists of
two detachable parts so as to ensure prop-
er cleaning. Flush both parts of the strainer
with clean water. Connect the parts before
the strainer element is re-installed. Re-
install the strainer element, grease the O-
ring and the thread with e.g. silicone oil or
teflon based spray, see drawing 11, and re-
install the lid.
N.B. Secure or loosen the lid always manu-
ally. Never use tools for this purpose, see
drawing 7 and 8.
Cooling water strainer model 1320, 1900
07-04-2005
08:43
Pagina 5
Cleaning model 1900
Close the seacock. Unscrew the knurled
knobs and remove the lid of the water
strainer, see drawing 9. Remove the strain-
er element out of the housing and flush the
strainer with clean water. Re-install the
strainer element, grease the sealing ring
with e.g. silicone oil or teflon based spray,
see drawing 12, and reinstall the lid.
N.B. Secure or loosen the knurled knobs
always manually. Never use tools for this
purpose, see drawing 9 and 10.
Check the seal between lid and housing
after cleaning and re-assembling the strain-
er. An improperly sealed lid will result in air
sucked in by the sea water pump of the
engine which again will result in overheat-
ing of the engine.
To prevent damage of the water strainer,
during frost in the winter time, either the
water must be drained or the instaliation
must be filled with anti-freeze.
Remove the hoses to drain the strainer; the
housing is not equipped with a drain plug.
Take care that during filling with anti-freeze
no anti-freeze is spilled into the waterway.
Anti-freeze is poisonous!
ENGLISH
5
030504.02
Werbung
Inhaltsverzeichnis
