Operating Elements - Monacor PA-24FMM Bedienungsanleitung

1
Insertion Module for
Emergency Announcements
These instructions are intended for the tech-
nician installing the insertion module and for
users without any expert knowledge. Please
read the instructions carefully prior to opera-
tion and keep them for later reference.
1 Applications
The module PA-24FMM is designed for
installation into MONACOR PA amplifiers
with insertion compartment and for installa-
tion into the basic unit PA-1200EX; however,
these instructions will not refer separately to
the basic unit. With this module, important
announcements can be made via the PA
amplifier. In addition, an emergency message
of up to one minute can be stored and auto-
matically replayed when an alarm is trig-
gered.
To send an alarm to additional units, a
relay with switching contact is available. This
relay will also respond when the hand-held
microphone is removed or when it is defec-
tive. As an additional alarm feature, an inte-
grated buzzer can be activated.
8
PA-24FMM
EMERGENCY ANNOUNCEMENT MODULE
10
0
MIC
2 3 4
RECORDING
L
BEEPER
ON
OFF
R
SIG CLIP PLAY
FAULT
10
0
LEVEL INPUT
5 6 7

2 Operating Elements

1 Support for the hand-held microphone
2 Jack to connect the hand-held micro-
phone
3 Volume control for microphone an-
nouncements
4 LED FAULT; keeps flashing when the
microphone is not connected, when the
microphone is defective and when an
alarm is triggered
5 Button BEEPER to activate / deactivate
the internal alarm buzzer
6 Control LEVEL for the volume of a
recording
7 RCA jacks for recording an emergency
announcement with line level (e. g. from
an MP3 player or a PC)
8 LEDs
SIG lighting up at a given volume of the
recording signal
CLIP lighting up to indicate overload
9 LED PLAY; keeps flashing while an
announcement is recorded or while a
stored announcement is replayed
10 Control LEVEL to adjust the volume when
replaying a stored emergency announce-
ment
11 Headphone connection (6.3 mm jack)
PLAY
³ 32 ½
0 10
LEVEL
8 9 10 11