Copy Function - Johansson Profiler Lite 6601 Bedienungsanleitung

COPY FUNCTION

This function allows to transmit all settings from one unit to another unit or import from the memory stick (optional).
Copy from unit to unit.
B I-II B III
I-II III
PROGRAMMABLE FILTER-AMPLIFIER
Stop Channel
Start Channel
Select Filter
Split UHF
+
15V IN
- Connect master and slave unit with a DSUB9 male/male crossed cable.
- Then connect mains to the units.
- Push on the rotary button for more than 3 seconds to enter into programming mode (see page 7).
- Turn the button to select the Data Import mode.
- Push the rotary button to enter the selected mode.
3 sec.
- Push the rotary button to confirm Data Import.
Note :
If a problem occurs during data transmission the display will show an error message :
Possible causes are : wrong type of cable, no cable, bad pin contacts.
UHF1 UHF2 UHF3
24V 24V 24V
1 2 3 4 5 6 7 8 9 10
UHF Clusters
All actions have to be
GND
R
done on the SLAVE unit.
MULTI CHANNEL
The MASTER unit remains
in Stand-by.
Digital
Terrestrial
Ref.: 6601
Manual Level
Auto Level
Data Import
Exit
Output
Test
(-30 dB)
SLAVE
Data
The software version is displayed,
followed by a dot.
3 sec.
Data Import
The LED is green.
Data Import
The LED is now RED colored.
AL is displayed
A dot is displayed.
17
B I-II B III UHF1 UHF2 UHF3
24V 24V 24V
I-II III 1 2 3 4 5 6 7 8 9 10
UHF Clusters
GND
R
MULTI CHANNEL
PROGRAMMABLE FILTER-AMPLIFIER
Digital
Terrestrial
Ref.: 6601
Stop Channel Manual Level
Start Channel Auto Level
Select Filter Data Import
Split UHF Exit
+
15V IN
Output
Test
(-30 dB)
MASTER