Pix-Star FotoConnect XD Benutzerhandbuch Seite 5

2. Installation and Power On
First, plug the AC adapter at the back of the device, then plug the AC adapter to a power
outlet/socket.
To turn on the device, move the switch button located on back/bottom side of the device next to
the AC adapter plug. After a few seconds, the screen should display a logo.
Wait for about 30 seconds for the device to be ready for use.
3. Introduction to the Main User Interface
After you power on the device and wait for approximately 30 seconds your Pix-Star will display the
main menu.
You can navigate the menus using the remote control or the buttons located behind the device on
the right side.
When the slide show is playing, to quit the slide show and go back to the main menu press the Back
button or the Menu button twice.
When the main menu is displaying on the Pix-star's screen, select the menu you want to enter using
the UP and DOWN buttons then press the / OK button to enter it.
Note: The Back button on the remote control allows you to go back to the previous menu (upper
level menu)
4