Comb Attachments - Braun BT 7050 Bedienungsanleitung

• During cordless use the charge indicator blinks green.
• The charge indicator flashes red when the battery is running low.
You should be able to finish your current trimming sequence.
BT 3050cb
• The charge indicator (5) shows that the appliance is being charged.
When the battery is fully charged, the charge indicator turns off.

Comb attachments

• The combs can be taken off by pressing the release buttons (1c) with
your thumb and forefinger.
Beard trimming
• Place the beard comb (1a) on the appliance with the appliance turned off (a).
• Press length selector (6) and slide the beard comb up to your desired
beard length (possible length settings: 1, 3, 5, 7, 9, 11 mm).
• It is advisable to begin with the highest setting and then reduce the
setting until you reach the desired beard length.
• Press the on/off switch (7). Hold the beard comb with the angled edge
against your beard and guide the trimmer against the direction of the hair
growth (a).
• To avoid clogging the beard comb with hair, clean it from time to time with
the brush.
Contour Trimming / Styling
• The wide trimmer (2) evenly cuts and trims large areas. It is ideal for
shaping sideburns, moustaches and partial short beards. Take off the
comb. While stretching the skin, guide the wide trimmer against the
direction of hair growth (b).
• The precision trimmer (3) precisely defines lines and edges and is ideal
for precise contouring. To use the precision trimmer, press the release
button (4) and slide it up (c).
Hair cutting
The hair should be clean, well combed, tangle-free and dry.
• Place the hair comb (1b) on the appliance with the appliance turned off (d).
• Press the length selector (6) and slide the hair comb up to your desired
hair length (possible length settings: 10, 12, 14, 16, 18, 20 mm). If you are
(1a, 1b)
13