Jet 81 Bedienungs- Und Wartungsanleitung Seite 3

3) USE AND INSTALLATION
a) Use:
The water pump is designed for everyday use such as gardening, sprinkler systems,
increasing water pressure of the non-feed water distribution network, pumping of tank
water and jet washing. The pump/booster assembly maximizes water storage by
limiting frequency of operation, and in particular ensures constant pressure is
maintained in the installation.
The pump must not be operated for uses not specified in this manual.
In particular, the pump must not be use for:
- Pumping of seawater, waste water, water containing solid bodies, sand or
abrasive particles in suspension, or water containing corrosive substances in
general.
- Pumping of water whose temperature exceeds 35℃
- Pumping of explosive, inflammable or dangerous liquids.
b) Major recommendations:
Before connecting up to the electricity network, you must:
- Fasten the pump securely to the ground or a suitable support.
With that in mind, the four feet of the tank have been perforated so as to allow
fastening bolts (not supplied) to go through.
- Ensure that the network voltage is the same as that stated on the pump
specification label.
ATTENTION!
The guarantee does not cover accidents due to installation. This pump must be
installed in accordance with the standards currently in force and by qualified
staff. We advise you to get in contact with an electrician.
The fixed pipes which the pump is to be connected up to must include a separation
device with contacts whose aperture is at least equal to 3 mm over all the poles.
If the pump is used for the operation of a swimming pool, it must be supplied with
power by means of an isolating transformer or by a circuit comprising a core balance
transformer with assigned operating residual current not exceeding 30 mA. The pump
must not be used in outside fountains, garden pools or similar situations.
NOTE: This pump is not designed to be used in pool cleaning or other pool
maintenance tasks. When used for the operation of a swimming pool, the pump must
be installed in an enclosed service room.
In addition, this pump is not designed for use in the pumping of liquid for human
consumption. Total manometric height must not exceed 35 m .the connecting cable
used must at a minimum be of the type H05 RNF-3x1 mm
GB
2
(Phase, neutral and earth).
3 / 26