General Remarks; Technical Data - Jet 81 Bedienungs- Und Wartungsanleitung

Directions for maintenance & use
SURPRESSOR PUMP JET 81-101-121
WARNING! In order to reduce the risks of fire, electric shock and personal injury
during the course of installation and use of your pump, it is recommended that you
always adhere to basic safety precautions, including the following:
Read these instructions in their entirety before operating this machine and
retain these instructions,

1) GENERAL REMARKS

The water pump is designed to suck up treated water.
The pump must be installed in a dry, ventilated location, not exposed to bad weather
and heat; the maximum suction height must not exceed 8 meters.
When correctly installed, your pump will operate with maximum efficiency and entirely
to your satisfaction: be sure to read the following instructions carefully.

2) TECHNICAL DATA

Water pumps may come equipped with tanks of stainless steel or steel with 19, 24, 36
or 50 liter capacity. The reference assigned depends on the type of tank supplied:
Capacity 19 L
Material
STEEL S.STEEL
used
JET 81 517616 517616I
JET101 517716 517716I
JET121 517816 517816I
The specifications set out below are the same irrespective of the tank supplied:
Model JET 81
Type Self-priming
Max suction 8 m
Output 28 l/min at 8m
Discharge 24l/min at 15m
Motor power 750 W
Power supply 230 V/ 50Hz
Speed
2850
(rounds / minute)
GB
24 L 36 L
STEEL S.STEEL STEEL S.STEEL
517636 517636I 517656
517736 517736I 517756
517836 517836I 517856
JET 101
Self-priming
8 m
33 l/min at 8m
28 l/min at 15m
970 W
230 V/ 50Hz
2850
2 / 26
50 L
STEEL S.STEEL
517656I 517676 517676I
517756I 517776 517776I
517856I 517876 517876I
JET 121
Self-priming
8 m
35 l/min at 8m
31 l/min at 15m
1180 W
230 V/ 50Hz
2850