Safety Instructions - AEG 5X69263MI1 Gebrauchsanleitung

combustion devices or other fuels. The hood must be
regularly cleaned on both the inside and outside (AT LEAST
ONCE A MONTH). This must be completed in accor dance
with the maintenance instructions provided in this manual.
Failure to follow the instruc tions provided in this user guide
regarding the cleaning of the hood and filters will lead to the
risk of fires. The flaming of foods beneath the hood itself is
severely prohibited.

1.SAFETY INSTRUCTIONS

The use of exposed flames is detrimental
to the filters and may cause a fire risk,
and must therefore be avoided in all
circumstances.
Any frying must be done with care in order
to make sure that the oil does not overheat
and ignite.
CAUTION: Accessible parts of the
hood may become hot when used with
cooking appliances.
For lamp replacement use only lamp type
indicated in the Maintenance/Replacing
lamps section of this manual.
WARNING! Do not connect the
appliance to the mains until the
installation is fully complete.
With regards to the technical and safety
measures to be adopted for fume
discharging it is important to closely follow
the regulations provided by the local
authorities.
The ducting system for this appliance must
not be connected to any existing ventilation
system which is being used for any other
purpose such as discharging exhaust fumes
from appliances burning gas or other fuels.
Do not use or leave the hood without the
lamp correctly mounted due to the possible
risk of electric shocks.
Never use the hood without effectively
mounted grids.
The hood must NEVER be used as
a support surface unless specifically
indicated.
Use only the fixing screws supplied with the
product for installation or, if not supplied,
purchase the correct screws type.
Use the correct length for the screws which
are identified in the Installation Guide.
In case of doubt, consult an authorised
service assistance centre or similar
qualified person.
WARNING! Failure to install the
screws or fixing device in accordance
with these instructions may result in
electrical hazards.
2.USE
The hood serves to aspirate the fumes and
vapors resulting from cooking.
The attached installation manual indicates
the version to be used depending on the
model you have, the suction version with
external evacuation
internal recirculation
3.INSTALLATION
The mains power supply must correspond
to the rating indicated on the plate situated
inside the hood. If provided with a plug
connect the hood to a socket in compliance
with current regulations and positioned in
an accessible area, after installation. If it not
fitted with a plug (direct mains connection)
or if the plug is not located in an accessible
area, after installation, apply a double
pole switch in accordance with standards
which assures the complete disconnection
of the mains under conditions relating to
over-current category III in accordance with
installation instructions.
Warning!Before re-connecting the hood
circuit to the mains supply and checking
the efficient function, always check that
the mains cable is correctly assembled.
ENGLISH 3
or filtering with
.