Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Speaker connection
· Never connect the speaker cables with the chassis ground. This could destroy
your amplifier.
· Check that your speakers are connected correctly which means plus to plus and
minus to minus
We recommend speaker cable from 2.5 mm² and up. Other connection
variations are shown attached.
2. BATT+
Battery + (plus) terminal. The + (plus) 12 Volt power cable must be connected
with a fuse on the battery + (plus) terminal. We recommend a 150 ampere ANL
fuse and a copper cable with a thickness of 35 mm² for cable length up to 5
metres.
3. REM
Remote terminal. The remote cable must be connected with the radio automatic
antenna terminal so that the amplifier will switch on and off automatically with
the radio. If there are 2 or more amplifiers connected to this antenna terminal it
might be necessary to add an additional relay. Please consult your dealer .
4. GND
Chassis ground-terminal. The chassis ground cable must be connected very
tight on a nearby massive and electric conductive place.
5. Remote Bass Level Control
When using the Remote Bass Level Control you have the ability to control the
level of the subs from the driver seat.
6. RCA audio-input
These RCA inputs are to be connected with your radio preamp RCA outputs.
Please use RCA cables made for car audio, otherwise there could be
disturbances. Keep these cables as short as possible. To avoid disturbances from
your car electronics, install the RCA cables not too close from existing car cables.
If your radio has only one preamp output please use a suitable Y-RCA adaptor . If
your radio has only speaker outputs you must use a HIGH-LOW-LEVEL adaptor .
8
Werbung
