Mounting Instructions; Electrical Installation - Toxic TXC-500 Bedienungsanleitung

MOUNTING INSTRUCTIONS

Investigate the layout of your automobile throughly before drilling or cutting any
holes. Take care when you work near the gas tanks, lines, or hydraulic lines,
and electrical wiring. Don't use the power amplifier unmounted. Attach this
system securely to the automobile to prevent damage, particularly in the event
of an accident. Don't mount this system so that the wire connections are unpro-
tected or are subject to pinching or damage from nearby objects.

ELECTRICAL INSTALLATION

These amplifiers are equiped with easy top access screw terminals. These
terminals are nickel plated to insure excellent electrical contact and to resist
corrosion.
See DIAGRAMS for electrical installation of all amplifiers. We suggest using
at least 10 mm² wire for the power
and ground connections. Wire the
amplifier directly to the car battery.
For the ground connection use the
shortest possible route to a good
chassis ground point. Wire the
remote connection to the auto start
lead of your equalizer or power
antenna.
Power fuses protects both this am-
plifier and the automobile electrical
fuse is standard automotive type. Replace only with the same current rating
fuse otherwise damage or fire can result.
NOTE:
The + 12VDC power wire must be fused at the battery positive terminal con-
nection. Before making or breaking power connections at the system power
terminals, disconnect the + 12V wire at the battery end. Confirm your radio /
cassette player and / or other equipment is turned off while connecting the input
jacks and speaker terminals.
If you need to replace the power fuse, replace it only with a fuse of different
type or rating may result in damage to this system which isn't covered by the
warranty.
Page 8
© TOXIC 2007