Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before first Use
Remove all parts from the packaging. Keep packaging material out of reach of
children. There is risk of suffocation!
Inserting/replacing the Battery
1. Unscrew the screw of the battery compartment lid (6) and remove the lid.
2. Carefully pull down the battery terminals and connect the battery, observe
right polarity. The unit needs a 9 V battery of the type 6LR61.
3. Insert the battery into the housing and tighten the battery compartment lid. Do
not tighten the screw too much.
Remove the spent battery as soon as possible and always replace the battery
with a fresh one of the same type. Leaking batteries can cause damage to the
electronic circuits.
ATTENTION! Do not use the inspection cameras with opened battery com-
partment lid!
Mounting the Gooseneck
1. Loosen the screw connection (3) by turning counter clockwise and connect
the gooseneck with the suitable socket on the housing. Please note the
gooseneck fits only in one position into the socket.
2. Tighten the screw connection by turning counter clockwise. Do not
overtighten the screw connection.
3. According to application, bend the gooseneck to the desired form.
ON/OFF Switch
1. To switch on the inspection camera, turn the ON/OFF switch (5) in direction
ON.
2. To switch off the unit, turn the ON/OFF switch in direction OFF.
Installation and Using
9
Werbung
Inhaltsverzeichnis
