Important Note - Storch 59 21 40 Bedienungsanleitung

GB
Thank you
for purchasing a STORCH product. You have purchased a quality product.
If you would like to suggest an improvement, or experience a problem with your product, please do not hesitate to
contact us.
Please contact your field sales representative or, in urgent cases, contact us directly.
Yours sincerely,
STORCH Service Department
Tel.:
Fax:
Free service hotline:
Toll-free order hotline:
Toll-free order fax:
Table of contents
1. Initial operation
2. If you take a break from work
3. Restarting work
4. Changing the foam can
5. Cleaning

Important note:

Always observe the foam manufacturer's instructions as printed on the can.
Please observe the correct use of the ball valve adapter (BVA).
Risk of escaping foam due to improper use
of the ball valve adapter!
1. Commissioning / Gun operation
BVA closed
Before screwing the can into the adapter, the BVA must be closed (= horizontal position).
Turn the adapter valve counter-clockwise until it is in the open position (= vertical).
When the expanding foam can is empty, close the ball valve (turn clockwise)
Hand-tighten the foam can on the adapter; when doing this make sure the can is vertical with the valve at the top to
avoid foam escaping when you screw the can on. The ball valve adapter is closed.
Shake the foam can thoroughly before use (follow the manufacturer's instructions and make sure the gun is fitted).
Open the ball valve adapter and the adjusting screw and start to use the foam immediately to completely fill the gun
with foam.
The foam gun is now ready for operation.
You can use the adjusting screw to adjust the volume of foam applied.
+49 (0)2 02 . 49 20 - 112
+49 (0)2 02 . 49 20 - 244
0800 786 72 47
+49 800 7867244
+49 800 7867243
(only available in Germany)
BVA open
10
Page
10
11
11
11
11