Parts Description; Technical Data; Security; General Safety Guidelines - AEG OL 8000 Bedienungsanleitung

1 Storage bag
1 Operating manual

Parts description


LC-Display
1
Button „LÖSCHEN / ERASE"
2
Button „LESEN / READ"
3
Connection cable with OBD II-plug
4

Technical Data


Article-No.:
Operating Voltage:
Storage Temperature:
Operating Temperature: 0 to 50 °C
Display:
Weight:
Dimensions:

Security


General safety
guidelines
WarnIng!
Read all safety guidelines and
instructions. Omissions regarding the compliance
to safety guidelines and instructions can cause
electrical shock, fire and/or serious injuries.
Keep all safety guidelines and instructions for
future reference.
J   DangEr OF accIDEnt anD LIFE
FOr InFantS anD cHILDrEn!
Never leave children unsupervised
with the packing material. There is danger of
suffocation.
97131
12 V via OBD
II–socket
20 to 70 °C
(04 to 158 °F)
(-32 to 122 °F)
LC-Display with back-
light illumination
approx. 250 g, incl.
cable
approx.
13,8 x 9,0 x 2,5 cm
(W x H x D)
Introduction / Security
J 
This device is not intended for use by persons
(including children) with reduced physical,
sensory or mental abilities or lack of experi-
ence and/or lack of knowledge unless they
are supervised by a person responsible for
their security or received instructions from
this person, how the equipment is to be
used. Children should be supervised, in order
to guarantee that they do not play with the
device.
J 
Liquid of any kind shall never penetrate the
device. Mortal danger exists by electrical
shock otherwise and danger of the damage.
J 
D o not let the device get into the hands of
children and store it inaccessible for chil-
dren. Small parts could be swallowed by
children and lead to death by suffocation .
Children could hurt themselves when using
this device.
J 
K eep the device away from children. Children
do not understand or recognise the possible
dangers in handling electrical devices.
J
attEntIOn! DangEr tO LIFE anD Dan-
gEr OF InjurY, DangEr OF DaMagE.
Secure the vehicle to prevent rolling before
checking it with the OBD II Diagnostic
Device OL 8000.
Always engage the hand-/ parking brake and
take care that it is not in gear during the
check. An automatic gear box must be set to
the „Park-Position"(P) and the hand-/ park-
ing brake must be engaged.
J 
T ake care that the device is always stored in
a secure place. Do not expose the device to
oils, grease, dampness, rain or wet ambient
conditions. Avoid that water or other liquids
run over the device or drip on it. Penetrating
water causes an electrical short circuit and
can damage the device or the vehicle.
J 
T ake care, that the device and the plugs are
free of dampness. Never connect the device
to the vehicle when hands are wet.
J
Do not expose the device to direct sun light.
J
Route the connecting cable in such a way,
that no one trips up and the cable gets
damaged.

GB 35