Cleaning And Care - RUSTA 307512260101 Gebrauchsanweisung

ENG
SOLAR PANEL INSTALLATION
1. To choose the mounting location, make sure the solar panel has direct and opulent
sunshine and that the LED Solar Sensor Light will not be directly exposed to rain.
2. Use the holes on the mounting plate of solar panel intended for the screws to mark
the positions for drilling.
3. Drill four holes in the mounting location, insert wall plugs and fix the solar panel with
screws.
4. Rotate and adjust the solar panel to a position for direct sunlight.
5. Connect the solar panel and LED light by plugs on their cables.
6. After initial installation, the product needs about 2 days for charging under direct and
opulent sunlight, before it can operate normally.
7. You can also use the 230V battery charger to fully charge the batteries before taken
into operation. If needed the batteries can also be re-charged later with the adapter
if solar panel charging is not enough. Simply take down the light and charge it with
the adapter in nearest 230v socket. During periods of little or weak sun this might be
needed depending on usage of light. Battery work time is approx. 1,5 hours on full
batteries.
230V BATTERY CHARGER
During periods when there is little sunlight the charger can be used to re-charge the
batteries. Simply dismantle the two screws and take light indoors to be charge in nearest
230V socket. The light on charger will show RED when chargin and GREEN when charg-
ing is complete.

CLEANING AND CARE

Use a slightly dampened, lint-free cloth and mild cleaning agent to clean.
Regularly check the motion detector for dirt.
Regularly clean the motion detector to ensure proper functionality.
6