De Dietrich AD252 Montageanleitung Seite 9

3 Pairing a remote control
The pairing must be done in the boiler room on first
initialisation.
Each radio remote control is given a unique identifying number in the
factory, which enables the boiler's radio module to recognise it. This
identifying number is transmitted to the boiler's radio module by the
pairing sequence described below.
This operation is memorised, even after the batteries are
changed.
1
Press the button on the boiler's radio module using the tip of a
ballpoint pen. The light on the boiler's radio module comes on.
The boiler's radio module exits the pairing programme after 2
minutes.
Press simultaneously for 5 sec. on keys
remote control.
The text cir A is displayed.
%
0 2 4 6 8 10 12
$
MODE
C002353-C
Turn the settings button to select the desired circuit.
Press the settings button to confirm the selection.
03/06/2009 - 300020522-001-B
3
2
and
14 16 18 20 22 24
4
5
After a few seconds, the light on the boiler's radio module
goes off and the remote control displays the message "init" while it
sychronises itself with the module.
After a few seconds, the message is cleared and the current display
appears.
Pairing failed
C002352-C
on the
If there is a problem, the warning light goes out after 2 minutes
and the remote control displays the message AL rF.
If the message AL rF appears, the boiler's radio module is not
paired with the radio remote control. Repeat the pairing sequence.
AD252
7
6
C002354-E
2
1
C002355-D
9