Cleaning And Storage - GALLIN YH-28 Gebrauchsanleitung

The device can be set to the standby mode by means of the
remote control. After the
the fan stops.
To switch on the device once more you press the
or any button on the device. The display shows the most recent temperature
setting and the heating process begins again.
9. Remove the mains plug from the socket after use.
Setting the Timer
The required operating time can be set at between 1 – 8 hours, after which the device
automatically switches off
1. Switch on the device (see the "Use" chapter).
2. Press the button (13) twice. "0H" (for 0 hours) fl ashes on the display. Set the
desired operating time by increasing it with the + button (11) / or reducing it with the
– button (12).
3. When the operating time is no longer visible on the display, you can select the tem-
perature (see the "Use" chapter). After that the display switches between the preset
operating time and the temperature.
4. The device stops the heating process automatically after the preset operating time
has elapsed and switches into the standby mode.

Cleaning and Storage

PLEASE NOTE!
■ Pull the mains plug out of the socket and allow the device to cool down completely
before doing any cleaning!
■ Do not use any caustic or abrasive cleaning agents for cleaning. These can damage
the surface.
• Dust down the device if necessary or wipe it down with a damp cloth if necessary.
Then wipe it dry with a dry cloth.
• When not in use, the device should be stored in a clean, dry place which is protected
from dust and is not accessible to children and animals.
19
button is pressed, it takes approx. 15 seconds until
(9) button on the
button on the remote control
EN