ZyXEL Communications NSA210 Bedienungsanleitung Seite 5

Install Hard Drive
Once you intall a hard drive on the NSA210 and create a volume, all
existing data on the disk will be erased.
The NSA210 must be turned off before you remove or install
hard drive.
Creating a volume formats the hard drive. All data will be lost.
Back up any files on the disk to another location before you
install the disk in the NSA210.
1. Make sure the power and Ethernet cords are disconnected from the
NSA210.
2. Place the NSA210 on a flat surface with the
bottom panel facing up. This exposes the bottom
panel where the thumbscrew is located. Loosen
the thumbscrew using a flat head screwdriver or
a coin.
3. Bring the NSA210 to an upright position and take
off the front lid to open the hard disk tray as
shown in the following:
ENGLISH
5