Hazet 9048 P-1 Betriebsanleitung Seite 14

• Do not use the tool in rooms with an
explosive atmosphere. Tools such as san-
ders can cause sparks that may ignite com-
bustible materials. Never operate tools in
proximity to combustible substances like
petrol, naphtha or detergents, etc. Work in
well-cleaned and well-ventilated areas only.
Keep combustible materials out of the work
area. Never use oxygen, carbon dioxide or
other bottled gases to power pneumatic
tools.
• Do not point the tool at another person.
Keep children and other persons out of the
work area when operating the tool.
• Do not operate the tool in an idle state.
• Do not allow pneumatic tools to come
into contact with sources of electricity.
• Pay attention to the working pressure. For
max. air pressure see table on page 15.
Exceeding the approved maximum pressure
of tools and accessories may cause explo-
sions and may result in severe injuries. The
maximum pressure of the compressed air
must be equal to or less than the approved
pressure load indicated for the sander.
• Check the air hose connections are fit­
ted tightly. Do not use defective pressu­
re hoses. Uncontrollably moving pressure
hoses may cause severe injuries.
• Only disconnect pneumatic tools in an
unpressurised state. Uncontrollably moving
pressure hoses may cause severe injuries.
• Only use clean and dry air. Never use oxy-
gen, carbon dioxide or other bottled gases
to power pneumatic tools.
• Only use spare parts, attachments and
accessories recommended by the manuf­
acturer.
• Never carry the tool by the compressed
air hose.
• Never carry the connected tool with a
finger on the operating lever.
• Avoid unintentional activation.
• Always keep the handles dry, clean and
free of grease or oil.
• Ensure that the working area is clean, well
ventilated and always well lit.
• Never use the tool whilst under the influ­
ence of alcohol or drugs.
14
2
For your safety
Always wear personal protective equipment!
^ hazet.com • ] info@hazet.de
• Repair work must be carried out exclusi­
vely by authorised persons.
• Labels on the tool must always be kept
legible. The user is responsible for ensu­
ring that the sticker stating warning
signs, rotation speed, the serial no. and
the article no. is not damaged and is easy
to read.