Bringing Into Use; Setting Up The Antenna - Schwaiger ZA2010 Bedienungsanleitung

• The contacts on the back of the device must not
come into contact with metal objects or your
fingers . Otherwise short-circuits could occur .
avoid the dangers of heat
and fire!
• The heat generated during operation of the
device must be allowed to dissipate by providing
adequate air circulation .
• Do not allow the device to be covered or placed
inside a closed cupboard .
• Ensure that the ventilation slots on the device are
not covered, e .g . by a table cloth or curtains .
• Ensure that there is a clear gap of at least 10 cm
around the device . Heaters or other sources of
heat near the device could lead to malfunctions
or damage to the device .
• Never stand sources of open flame, such as
burning candles, on the device .
avoid danger to life!
• Make sure you set the device down in a stable
position on a suitably firm supporting surface .
If the device falls on anyone it could cause
injury .
• Make sure that the mains lead does not present
a trip hazard . It can help if you lead it away from
the rear of the device .
using the device properly
and safely
• Always set the device down on a suitable
surface . Delicate items of furniture could suffer
colour changes from the heat generated by the
device .
• The device is intended for use in a dry environ-
ment and temperate climate .
• Do not place the device in rooms with high humi-
dity, e .g . kitchens, bathrooms etc ., as droplets
of condensed water or splashes of water could
damage it .
12
ZA2010_2.indd 12
• Condensation can occur inside the device if it
is taken out of a cold into a warm place . In this
case let the device stand for a few hours before
switching it on .
• Always ensure that the indoor antenna stands
on a level, dry surface .
• Make sure that the device is not subject to strong,
direct sunlight, vibrations, dust, heat, cold or
moisture .
• Do not set the device up near appliances or
equipment that create strong magnetic fields
(e .g . microwave ovens, mobile phones, motors,
loudspeakers or transformers) .
• To disconnect the electrical supply pull the plug
out of the mains socket .
Pull out the mains plug in the following circum-
stances:
- During electrical storms .
- If the device is going to be out of use for a
prolonged period .
- Before you clean the device .

Bringing into use

Setting up the antenna

• Always ensure that the indoor antenna stands
on a level, dry, stable surface .
• Position the antenna near the receiver .
note: Setting the device up near a window can
improve reception .
• If reception is not satisfactory after connecting
and setting up the antenna, try changing the
direction of the antenna or its location to achieve
the best possible reception .
note: In some cases reception may not be perfect,
even after you have found the optimum position and
direction of the antenna . Reception can be obstruc-
ted by various objects, e .g . reinforced concrete
walls, large metal surfaces, tall trees, high buildings
and hills .
Programs are transmitted by different stations and it
will probably be necessary to redirect the antenna
when you switch stations .
23.01.2009 10:08:39 Uhr