Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Charging the battery
Fully charge up the battery before you first use the scooter and after each ride. The maximum charging
time is approx. 6 – 8 hours. If the charging time is significantly longer, please read the „Troubleshooting"
section.
You should charge the battery ideally at room temperature. Do not charge it at temperatures of below
0°C or above 40°C!
•
Park the scooter on its stand close to a plug socket and make sure that the scooter is switched off
(key position).
•
Push the cover of the charger socket to the side.
•
Plug the 3-pole charger plug into the charger socket.
•
Connect the mains plug of the charger to a properly installed and easily accessible mains socket. The
mains voltage must be the same as that stated in the technical data of the charger.
•
As soon as the charger is connected to the power supply and to the battery, the red charger indicator
light comes on.
•
Charging stops automatically when the battery is fully charged - the indicator light now changes from
red to green.
•
Disconnect the charger first from the mains supply and then from the battery. Store it out of the
reach of children. Slide the cover over the charger socket of the battery.
The unit is supplied with standard auto valves. Before each ride, whether the tires are properly inflated.
The ideal tire pressure is 3 bar. Do never fill the tire with more than 3.5 bar.
Make yourself familiar with the controls before you set off for your first ride.
•
Switching on and off
The scooter is switched on and off by turning the key in the ignition clockwise / anti clockwise.
•
Accelerating and braking
Slowly turn the accelerator throttle towards you. Regulate the speed
however you want by turning the accelerator throttle. Only accelerate
when you feel confident enough to do so.
If you want to brake, let go of the accelerator throttle and press both
brake levers. Use the right-hand brake lever to apply the front-wheel
brake and the left-hand brake lever to apply the rear-wheel brake.
When you activate a brake lever, the motor is automatically switched off.
•
It is essential that you fully charge up the battery before
you first use the scooter.
•
The battery may not be completely discharged because
this could damage it.
•
Only use the charger indoors and in the dry.
•
The contacts of the charger must remain free of dust and
dry at all times.
•
If the scooter and the battery are not used for a lengthy
period of time, the battery should be fully charged up be-
fore it is stored away in order to avoid a deep discharge.
•
Risk of short-circuits! After charging, be sure to push the
cover over the charger socket of the battery
Operation
Inflating the tyres
Controls
24
Werbung
Inhaltsverzeichnis
