Hardware Installation - Stardom ST8-S2P Bedienungsanleitung

3. Hardware Installation

Please follow the instructions below to complete the hardware installation:
Step1 Open the package and take out the product making sure that all the enclosed
contents are not damaged or missing. If there are damages or missing contents,
please contact your supplier immediately.
Step2 Place the enclosure on a stable surface, ensure that it is well ventilated without
blockage to the vent and kept away from locations near water or where the
product may become vulnerable resulting in damages.
Step3 Use the provided key in the accessory kit and inserted into the key access
opening to eject the removable drive tray latch and extract the removable drive
tray.
Step4 Remove the drive stabilizer from the removable tray then mount the hard drive
onto the tray and secure it with the screws enclosed in the accessories kit. Once
completed, insert the drive tray back from the drive position A and push the latch
into place. Repeat the same for drive position B.C.D.E.F.G.H to complete all drive
installations.
Step5 Use the provided cables and use one end to connect to the interface connections
on the enclosure unit and the other end to the computer system.
Step6 Attach the AC power cable to the power socket. Once completed, you may power
on the unit.
Make sure the interface connection has been made to your computer. When
your computer has booted, your operating system should recognize the device
automatically. After the device has been successfully recognized, please follow
the formatting of hard drive instructions given by the operating system to format
the drive volume to your preference. Once the formatting has been completed, the
device is ready for use.
STARDOM SOHOTANK Series User Manual
6