Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3 English
GENERAL ADVICE
Space heaters must be installed, set up and used in accordance
with current laws.
A few general guidelines should be observed:
• follow the instructions in this booklet very carefully;
• do not install the heater near showers, bathtubs or swimming
pools;
• do not place the heater immediately beneath a fixed wall socket;
• the heater must be placed on a firm surface to avoid overturning;
• inflammable materials must be kept at a safe distance from
theheater;
• the heater must not be covered;
• make sure the heater is always under surveillance and keep
childrenand animals away from it;
• after use make sure the disconnecting switch is off.
INSTALLATION INSTRUCTIONS
Warning
Use the four screws provided to fix the feet as shown in
the picture before using the heater.
Heater must be connected to a 230V ~ grounded wall
Socket.
Before any attempt to start the heater is made, check that your
electrical supply conforms to the data on the model plate.
Warning
Mains must be fitted with a thermo-magnetic differential
switch.
The unit plug must be linked to a socket with a mains
switch.
INSTRUCTIONS
THERMOSTAT 0-55 C°
Turn on the ON-OFF switch (a).
By setting the room thermostat to the desired temperature level,
the
heater will start and stop automatically.
POWER SELECTOR
You can choose power delivery using the selector (b) as follows:
TEMPERATURE-LIMIT THERMOSTAT
A temperature-limit thermostat will stop the power supply in
caseof overheating.
POSTVENTILATION
When the room temperature reaches the value of the valve on
thethermostat, the heating stops and the fan goes on until the
resistanceshave cooled down.
MAINTENANCE
Warning
Before carrying out any maintenance operation you must:
• Stop the heater;
• Turn off the disconnection switch on the electric switchboard;
• Wait until the heater has cooled down.
Werbung
