Operation - Inelco Dania Bedienungsanleitung

SPACE HEATER 9 kW
GB
Operating Instructions
Connection
Connect space heater to mains supply through plug. Be sure to mount plug correctly.
5 pin 400V 3~

Operation

Switch on unit and start space heater by adjusting the function switch (1) to the position required.
3 kW 6 kW
In general
The space heater is equipped with an adjustable thermostat. The temperature required is set by means of the
adjustment button (2) after which the heater runs automatically. Before switching off the heater, it is
recommended to interrupt the heating elements and to change over to Fan for a couple of minutes in order to
cool the unit before switching over to Off or before interrupting the mains supply. If, however, the heater is
interrupted by means of the main switch or if the current falls out and the thermal cut-out is thereby activated,
RESET (3) thermal cut-out when the heater has been cooled off.
PV Version (Post Ventilation)
Each time the heating elements are turned off (heating temperature reached) by the thermostat it results automatic fan
operation within 3 minutes
Warning

Do not cover! Risk for fire if the heater is covered.

Minimum distance from inflammable materials is 0.5 m!

Do not use the equipment in the immediate vicinity of washbasin, bath, shower, swimming pool!

Do not use in areas with fire risk!

Must not be located immediately below a socket-outlet!
Maintenance -
Clean the space heater with compressed air when it is disconnected from the mains.
IMPORTANT! The transverse thermostat feeler incl. V-fitting on the front grille must be kept clean in
order to avoid disconnection of the thermostat.
GUARANTEE
KEEP VALID RECEIPT OR GUARANTEE CARD
To obtain guarantee within the guarantee period, it is an absolute MUST that either a valid receipt or the
guarantee card is submitted to the service station together with the appliance.
10

9 kW
3
6
0
9
1
4 pin
Fan
RESET
3
400V 3~

0 Off
MAX
MIN
2