Battery Replacement - V7 UPS1RM2U1500 Bedienungsanleitung

6. Turn on the UPS
Press the ON/Mute Button on the front panel for two seconds to power on the UPS.
Note: The battery charges fully during the first five hours of normal operation. Do not expect full battery run
capability during this initial charge period
7. Install software (Optional for advanced users)
For optimal computer system protection, install UPS monitoring software to fully configure the UPS system. Please
follow steps below to download and install monitoring software.
1. Go to the website http://www.V7-world.com/downloads
2. Select ViewPower software for your operating system to download the software.
3. Follow the on-screen instructions to install the software.

1.5 Battery Replacement

Note: This UPS is equipped with internal batteries and only a trained technician should replace the batteries.
Caution! – Adhere to all warnings, cautions, and notes before replacing batteries.
Note: When battery is disconnected, equipment is not protected from power outages.
1
Remove front panel
3
Pull out the battery box by removing two screws
on the front panel
5
After replacing the batteries,
put the battery box back to the
its original location and screw
it tightly
2
Disconnect battery wires
4
Remove the top cover of battery box and replace
the inside batteries
6
Re-connect the battery wires
7
Put the front panel back on the unit