Soba XC510 Gebrauchsanleitung Seite 8

XC510 AIR CONDITIONER/DEHUMIDIFIER
SETTING UP
1. Remove the cover from the back of the remote control.
2. Insert two AAA batteries (batteries not included).
3. Plug into the mains.
4. Always point the remote control towards the unit when you want to use it.
5. Make sure that there is nothing obstructing the signal path.
6. The maximum distance between remote control and appliance is 7.9 metres.
7. Remove the batteries if the remote control is not going to be used for some time.
A change in the function is usually indicated by a beep.
Note:
• Do not zap with the remote control.
• Do not expose the remote control to direct sunlight or leave it next to a radiator or
other source of heat.
• Do not use rechargeable batteries as they differ from standard dry cell batteries in
shape, size and performance.
• Be sure to replace the batteries with two new batteries of the same type.
Remote control functions
1. LCD Display
2. Mode selection
button to select AUTO, COOL, DRY or
HEAT functions
3. Temperature UP and Down setting
buttons: Press
temperature.
temperature.
4. Fan speed selection button: Press this
button to select the fan rotation speed.
Fan speed cannot be adjusted when the
unit is in DRY mode.
5. Sleep function button: Press once to
switch to Sleep function. Press twice to
switch off the Sleep function.
6. "ON Timer" button: Set the Timer On
function as follows: the remote control
unit is switched off; no time shown on
the display. Press "ON Timer" button >
On Timer signal flashes. > Press "Hour"
or "Minute" button until the required
time is shown. > Press "ON Timer"
button to set the desired time > ON
Timer signal stops flashing. Press "ON
Timer" button again to cancel the "ON
Timer" setting.
button: Press
"+" to increase
Press "-" reduce
this
1
2
4
9
3
8
INSTRUCTIONS
5
6
7
8